Difference between revisions of "Set up vm-bhyve in FreeBSD"
(→= Configure networking) |
(→Configure Install) |
||
| Line 19: | Line 19: | ||
zfs create -o mountpoint=/vm tank1/vm | zfs create -o mountpoint=/vm tank1/vm | ||
| + | cp /usr/local/share/examples/vm-bhyve/* /vm/.templates/ | ||
Add to rc.conf: | Add to rc.conf: | ||
Revision as of 14:19, 19 November 2019
Contents
Introduction
vm-bhyve is a bhyve manager for FreeBSD.
Prerequisites
Recent enough FreeBSD with ZFS. All commands below run as root.
Install
pkg install vm-bhyve pkg install grub2-bhyve bhyve-firmware # For non-FreeBSD guests
Configure
Configure Install
zfs create -o mountpoint=/vm tank1/vm cp /usr/local/share/examples/vm-bhyve/* /vm/.templates/
Add to rc.conf:
vm_enable="YES" vm_dir="zfs:tank1/vm"0"
Then run:
vm init
Configure networking
vm switch create public vm switch add public bge0
