Difference between revisions of "Set up iohyve in FreeBSD"
(Created page with "== Introduction == [https://github.com/pr1ntf/iohyve iohyve] is a bhyve manager for FreeBSD, similar to [https://iocage.readthedocs.io/ iocage]. == Prerequisites == Recent...") |
(→Bugs) |
||
| (12 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
| + | [[Category:FreeBSD]] | ||
| + | |||
== Introduction == | == Introduction == | ||
| Line 22: | Line 24: | ||
iohyve_enable="YES" | iohyve_enable="YES" | ||
iohyve_flags="kmod=1 net=bge0" | iohyve_flags="kmod=1 net=bge0" | ||
| + | |||
| + | == Bugs == | ||
| + | |||
| + | With non-UEFI guests, iohyve [https://github.com/pr1ntf/iohyve/issues/305 can't set RTC to UTC]. You need to either [[Configure Linux distributions that use systemd to use local time for RTC|set-up guests to use localtime]], or pass extra parameters to bhyve like this: | ||
| + | |||
| + | iohyve set ''guest'' bargs=-A_-H_-P_'''-u''' | ||
| + | |||
| + | Iohyve is unmaintained, perhaps try [[Set up vm-bhyve in FreeBSD | vm-bhyve]]. | ||
| + | |||
| + | == See also == | ||
| + | |||
| + | * [[Set up vm-bhyve in FreeBSD]] | ||
| + | |||
| + | == References == | ||
| + | |||
| + | * [https://github.com/pr1ntf/iohyve/wiki/Manual iohyve(8)] | ||
Latest revision as of 16:03, 19 November 2019
Introduction
iohyve is a bhyve manager for FreeBSD, similar to iocage.
Prerequisites
Recent enough FreeBSD with ZFS. All commands below run as root.
Install
pkg install iohyve pkg install grub2-bhyve # For non-FreeBSD guests
Configure
iohyve setup pool=tank1 kmod=1 net=bge0
Adjust ZFS pool and NIC as needed.
Add to rc.conf:
iohyve_enable="YES" iohyve_flags="kmod=1 net=bge0"
Bugs
With non-UEFI guests, iohyve can't set RTC to UTC. You need to either set-up guests to use localtime, or pass extra parameters to bhyve like this:
iohyve set guest bargs=-A_-H_-P_-u
Iohyve is unmaintained, perhaps try vm-bhyve.
