Difference between revisions of "Set up vm-bhyve in FreeBSD"
(Created page with "Category:FreeBSD == Introduction == [https://github.com/churchers/vm-bhyve vm-bhyve] is a bhyve manager for FreeBSD. == Prerequisites == Recent enough FreeBSD with ZFS...") |
(→Configure) |
||
| Line 22: | Line 22: | ||
vm_enable="YES" | vm_enable="YES" | ||
vm_dir="zfs:tank1/vm"0" | vm_dir="zfs:tank1/vm"0" | ||
| + | |||
| + | Then run: | ||
| + | |||
| + | vm init | ||
== References == | == References == | ||
Revision as of 14:02, 19 November 2019
Introduction
vm-bhyve is a bhyve manager for FreeBSD.
Prerequisites
Recent enough FreeBSD with ZFS. All commands below run as root.
Install
pkg install vm-bhyve pkg install grub2-bhyve bhyve-firmware # For non-FreeBSD guests
Configure
zfs create tank1/vm
Add to rc.conf:
vm_enable="YES" vm_dir="zfs:tank1/vm"0"
Then run:
vm init
