Difference between revisions of "Set up vm-bhyve in FreeBSD"
(→Configure) |
(→Configure) |
||
| Line 16: | Line 16: | ||
== Configure == | == Configure == | ||
| − | zfs create tank1/vm | + | === Configure Install === |
| + | |||
| + | zfs create -o mountpoint=/vm tank1/vm | ||
Add to rc.conf: | Add to rc.conf: | ||
| Line 26: | Line 28: | ||
vm init | vm init | ||
| + | |||
| + | === Configure networking == | ||
| + | |||
| + | vm switch create public | ||
| + | vm switch add public bge0 | ||
== References == | == References == | ||
Revision as of 14:17, 19 November 2019
Contents
Introduction
vm-bhyve is a bhyve manager for FreeBSD.
Prerequisites
Recent enough FreeBSD with ZFS. All commands below run as root.
Install
pkg install vm-bhyve pkg install grub2-bhyve bhyve-firmware # For non-FreeBSD guests
Configure
Configure Install
zfs create -o mountpoint=/vm tank1/vm
Add to rc.conf:
vm_enable="YES" vm_dir="zfs:tank1/vm"0"
Then run:
vm init
= Configure networking
vm switch create public vm switch add public bge0
