Difference between revisions of "Set up iohyve in FreeBSD"
(→Bugs) |
(→Bugs) |
||
| Line 27: | Line 27: | ||
== Bugs == | == Bugs == | ||
| − | With non-UEFI guests, iohyve [https://github.com/pr1ntf/iohyve/issues/305 | + | With non-UEFI guests, iohyve [https://github.com/pr1ntf/iohyve/issues/305 can't set RTC to UTC]. You need to set-up guest to use localtime. |
== References == | == References == | ||
* [https://github.com/pr1ntf/iohyve/wiki/Manual iohyve(8)] | * [https://github.com/pr1ntf/iohyve/wiki/Manual iohyve(8)] | ||
Revision as of 11:00, 20 March 2019
Introduction
iohyve is a bhyve manager for FreeBSD, similar to iocage.
Prerequisites
Recent enough FreeBSD with ZFS. All commands below run as root.
Install
pkg install iohyve pkg install grub2-bhyve # For non-FreeBSD guests
Configure
iohyve setup pool=tank1 kmod=1 net=bge0
Adjust ZFS pool and NIC as needed.
Add to rc.conf:
iohyve_enable="YES" iohyve_flags="kmod=1 net=bge0"
Bugs
With non-UEFI guests, iohyve can't set RTC to UTC. You need to set-up guest to use localtime.
