Difference between revisions of "Set up vm-bhyve in FreeBSD"
(→Install) |
(→Install) |
||
| Line 11: | Line 11: | ||
== Install == | == Install == | ||
| − | pkg install vm-bhyve qemu-utils | + | pkg install vm-bhyve qemu-utils cdrkit-genisoimage |
pkg install grub2-bhyve bhyve-firmware # For non-FreeBSD guests | pkg install grub2-bhyve bhyve-firmware # For non-FreeBSD guests | ||
Revision as of 14:30, 19 November 2019
Contents
Introduction
vm-bhyve is a bhyve manager for FreeBSD.
Prerequisites
Recent enough FreeBSD with ZFS. All commands below run as root.
Install
pkg install vm-bhyve qemu-utils cdrkit-genisoimage pkg install grub2-bhyve bhyve-firmware # For non-FreeBSD guests
Configure
Configure Install
zfs create -o mountpoint=/vm tank1/vm cp /usr/local/share/examples/vm-bhyve/* /vm/.templates/
Add to rc.conf:
vm_enable="YES" vm_dir="zfs:tank1/vm"0"
Then run:
vm init
Configure networking
vm switch create public vm switch add public bge0
